Bath|Flooring|Flooring/Dining Area Flooring|Flooring/Entrance & Walk-Off Flooring|Kitchen
Installation
Installing your stone skirting boards couldn't be simpler: Take measurements. Measure the sections of wall on which the skirting boards will be installed. Make sure to clearly mark any inside or outside corners. Cut the baseboards. Use a specific saw to cut your baseboards. To check that your baseboards are cut correctly, do a dry run. To anticipate cuts or other unforeseen circumstances, Ligerio recommends buying 10% more than the initial quantity planned. Install your baseboards. Before gluing your baseboards, check that the bottom of your wall is flat, clean, and dry. Then, apply the adhesive in a zigzag pattern along the entire length of the baseboard. Don't forget the corners! Position the baseboard against the bottom of the wall and hold it in place for a few moments. Finally, clean up any excess adhesive. Once the baseboards are installed, it's time for the finishing touches. Apply the sealant along the entire length of the baseboard, where it meets the flooring and the wall. Apply a thin bead of sealant. If there are any irregularities, add more sealant. For a more aesthetically pleasing look, choose a stone-colored sealant
Performance Metrics
Light Blocking
Unknown
Maintenance
Regarding maintenance, it is similar to that of reconstituted stone paving. After installation, a specific water repellent for reconstituted stone must be applied. Note that this product must be applied to a dry and clean surface
